Vintage to OHC Red Block Conversion Mounts

Vintage to OHC Red Block Conversion Mounts
  • Click to enlarge
  • Click to enlarge
  • Click to enlarge
  • Click to enlarge

5.0 average, based on 1 reviews

$190.00


Product Information
Specification

These mounts allow fitment of a OHC redblock into a chassis that was orignally equipped with a pushrod redblock. These are an improvement over that setup as they use the original rubber mounts for your car instead of fussing with offset 240 mounts. They place the engine in the exact spot as the orignal allowing your transmission mounts and drive shaft to work.

If you are plannning to use these with a 140, please select so with the drop down menu on the right, as the mounts are different than the other vintage models.

Product Code 117_VIN8AG542
Manufacturer Yoshifab
Condition New
Weight 10.100lb

Customer Reviews

Average Rating: 5

B230 into 140 goes well!

1 2 3 4 5
Note that Yoshifab offers two different types of mounts - ones that fit the B230 engine family into 1800 engines bays, and others that fit the OHC engine into the 140 series - the 1800 type adapter brackets have a bit longer 'reach' than the 140 brackets. These engine mounting brackets use standard style 140 type rubber mounting blocks to mount to the crossmember. They mount the OHC engine upright, and maintain the original B18 or B20 engine's relative position. The brackets attach to the B230 family (or B21 family) engine block using three M8 x 15mm bolts on each side, so you don't need any of the old 240 or 740 hardware. I'm very pleased with the build quality and workmanship of the product, and with Yoshifab's excellent customer service. (Jun 09 2020, 01:47 AM)
Write a review

Write Review

Please enter a valid email address.
This field is required.
Top

eCommerce by CubeCart